Octavia III 2013 ➤ , Octavia III 2014 ➤
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
3.2.3
Removing and installing exhaust gas
temperature transmitter 2 - G448- (en‐
gine identification characters CRKB,
CRMB, CUNA)
Special tools and workshop equipment required
♦ Set of tools - T10395 A-
Removing
Note
Fit all cable straps on again in the same place when installing.
♦
When removing, the electric cable must be not cut off, since
♦
doing so would mean that fault diagnosis would no longer be
possible.
– Remove engine cover
⇒ "1.1 Removing and installing engine trim panel", page 10
– Disconnect plug connection -3- and lay the electric cable to
one side.
– Unscrew exhaust temperature transmitter 2 - G448- -arrow-.
Install
Installation is performed in a similar way in the reverse order. Pay
attention to the following points:
Caution
Malfunction caused by a loose exhaust gas temperature trans‐
mitter.
♦ the thread of the temperature transmitter 2 - G448- is
coated. It must NOT be coated additionally with hot bolt
paste and must be tightened to the specified tightening
torque.
Note
Protect exhaust gas temperature transmitter from impacts and
shocks: Do not use any exhaust gas temperature transmitter that
has been dropped.
Fitting position of the exhaust gas temperature transmitter 2 -
G448- :
406
Rep. gr.26 - Exhaust system
.