Skoda Octavia III 2013 Workshop Manual page 345

– Expose fuel return-flow hose -1-.
– Open holding clamps -arrows-, unclip and remove cable duct
-2-.
– Disconnect electrical plug connections:
1 - for fuel pressure sender - G247-
3 - for fuel pressure regulating valve - N276-
– Loosen hose clamp -4-, pull off fuel return-flow hose.
– Unscrew high pressure line union nuts -2-.
– Remove high pressure line and place it on a clean cloth.
– Screw out screws -arrows- and remove fuel distributor.
Install
Installation is performed in the reverse order, pay attention to the
following points:
– Follow all instructions for installation of high pressure lines
⇒ "2.9.2 Installing high pressure line", page 335
Tightening torques
♦ ⇒ "2.1 Summary of components - injection units (injectors)",
page 323
♦ ⇒ "2.2 Fuel distributor - summary of components", page 325
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
.
Octavia III 2013 ➤ , Octavia III 2014 ➤
2. Injection units/fuel distributor
337