Removing And Installing Engine Speed Transmitter G28 - Skoda Octavia III 2013 Workshop Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
– Release screws -arrows-, push the right charge air pipe slight‐
ly to the side.
– Separate electrical plug connection -2-.
– Unscrew screw -1-, pull off Hall sender - G40- .
Install
Installation is carried out in the reverse order.
♦ Tightening torque
⇒ "1.1 Summary of components - preheating system ",
page 420
1.5 Removing and installing engine speed
transmitter - G28-
Special tools and workshop equipment required
♦ Assembly tool - T10118-
♦ Socket insert size 4 - T10370-
Removing
– Remove the sound dampening system ⇒ Body Work; Rep.
gr. 50 .
– Disconnect electrical plug connection -1- using the assembly
tool - T10118- .
Note
To unlock the electrical plug connection without the assembly tool
- T10118- , use a screwdriver to press plug on the engine speed
transmitter and simultaneously raise release button with a thin
wire hooklet.
– Unscrew screw -2-, remove engine speed transmitter - G28- .
Install
Installation is performed in the reverse order, pay attention to the
following points:
Tightening torque
♦ Summary of components - preheating system
⇒ "1.1 Summary of components - preheating system ",
page 420
424
Rep. gr.28 - Glow plug system