Skoda Octavia III 2013 Workshop Manual page 139

1 - Oil drain plug
❑ 5 Nm
2 - O-ring
❑ replace after removal
3 - Screw cap
❑ 25 Nm
4 - O-ring
❑ replace after removal
❑ wet with engine oil
5 - Oil filter element
❑ pay attention to note
⇒ page 127
❑ removing and installing
⇒ Maintenance ; Book‐
let Octavia III
6 - Gasket ring
❑ captive, replace if the oil
pressure switch has
leaks
7 - Oil pressure switch - F1-
❑ Switching pressure
0.25 ... 0.32 MPa (2.5 ...
3.2 bar)
❑ Isolation brown
❑ check ⇒ Vehicle diag‐
nostic tester.
❑ removing and installing
⇒ "1.7 Removing and in‐
stalling oil pressure
switch F1 ", page 139
❑ 20 Nm
8 - Screw
❑ replace after removal
❑ Tightening torque and tightening order
9 - Oil filter housing with engine oil cooler
❑ Oil filter housing and engine oil cooler must not be disconnected
❑ removing and installing
⇒ "1.4 Removing and installing the oil filter holder with the engine oil cooler", page 132
10 - Screw
❑ replace after removal
❑ Tightening torque and tightening order
11 - Gasket
❑ replace after removal
12 - Gasket ring
❑ replace after removal
13 - Oil pressure switch for reduced oil pressure - F378-
❑ Switching pressure 0.03 ... 0.06 MPa (0.3 ... 0.6 bar)
❑ Insulation green
❑ check ⇒ Vehicle diagnostic tester.
❑ removing and installing
⇒ "1.8 Removing and installing oil pressure switch for reduced oil pressure F378 ", page 140
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
⇒ page 132
⇒ page 132
Octavia III 2013 ➤ , Octavia III 2014 ➤
1. Removing and installing parts of the lubrication system
131