Skoda Octavia III 2013 Workshop Manual page 348

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
– Place counterholder - T10051- at the high pressure pump
toothed belt pulley.
– Tighten nuts -arrow- hand tight.
– Pull off rig pin -T10492- , carefully turn high pressure pump
shaft in stress-free position.
– Unscrew nuts -arrow-, remove counterholder - T10051- .
– Remove the high pressure pump toothed belt pulley.
– Suspend extractor -T10489- at the hub by turning to the right.
– Remove the hub of the high pressure pump.
– Remove fuel return-flow hoses -2-.
– Separate electrical plug connection -1-.
– Unscrew screws -arrows-.
– Carefully remove the high pressure pump.
Install
Installation is performed in the reverse order, pay attention to the
following points:
– Place hub -arrow- on the high pressure pump shaft.
• The key on the high pressure pump shaft must engage into
the slot in the hub.
340
Rep. gr.23 - Mixture preparation - injection