Octavia III 2013 ➤ , Octavia III 2014 ➤
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
– Open valve -A-.
•
The vacuum pump in the cooling system draws the coolant out
of the coolant reservoir -VAS 6096- and fills the cooling sys‐
tem.
– Remove the cooling system charge unit - VAS 6096- from the
coolant expansion tank.
– Fill up coolant up to "Max" marking.
Note
Hose connections and air guide pipes and hoses must be free of
oil and grease before being installed.
– Install the noise insulation ⇒ Body Work; Rep. gr. 50 .
– For vehicles with auxiliary heating, switch it on for approxi‐
mately 30 seconds.
– Set temperature to "HI".
– Switch off AC compressor. Press
•
The LED in the button must not illuminate.
– Fill and bleed coolant circuit ⇒ Vehicle diagnostic tester,
,
geted Functions
– Allow the engine to warm up until the thermostat has opened
or the radiator fan has been activated once.
– Allow engine to cool down.
– Check coolant level.
– Top up coolant to approximately 5 mm above the "Max" mark‐
ing.
Note
During driving, any residual air quantities are discharged via the
permanent vent lines.
– Check coolant level.
•
If the engine is cold the coolant level must be between the
"Min" and "Max" marking.
•
When the engine is at operating temperature the coolant level
may be at the "Max" marking.
– If necessary, top up with coolant.
156
Rep. gr.19 - Cooling
button to do so.
AC
coolant circuit filling
Tar-
.