Work procedure
Note
If the stripped engine is replaced after engine removal, the
♦
tightening of the injection unit clamping claws on the new strip‐
ped engine must be checked. Specified torque: Position -8-
⇒ "2.1 Summary of components - injection units (injectors)",
page 323
.
The engine is removed downwards together with the gearbox.
♦
Fit all cable straps on again in the same place when installing.
♦
Fit all heat protection sleeves on again in the same place when
♦
installing.
WARNING
Danger of scalding due to hot steam and hot coolant.
♦ When the engine is warm, the cooling system is under
overpressure.
♦ Reduce excess pressure by covering the cap of the cool‐
ant expansion tank with a cloth and opening it carefully.
– Remove assembly bracket -9- without steering gear ⇒ Chas‐
sis; Rep. gr. 40 .
– Remove the front left and right wheelhouse liner ⇒ Body Work;
Rep. gr. 66 .
– Drain coolant
⇒ "1.2 Draining and filling coolant", page 151
– Remove engine cover
⇒ "1.1 Removing and installing engine trim panel", page 10
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
Octavia III 2013 ➤ , Octavia III 2014 ➤
.
.
1. Removing and installing engine
11