Senders And Sensors; Removing And Installing Intake Air Temperature Transmitter G42 / Charge Air Temperature Transmitter After Charge Air Cooler G811; Removing And Installing Fuel Temperature Transmitter G81 - Skoda Octavia III 2013 Workshop Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
4

Senders and sensors

⇒ "4.1 Removing and installing intake air temperature transmitter
G42 / charge air temperature transmitter after charge air cooler
G811 ", page 342
⇒ "4.2 Removing and installing fuel temperature transmitter G81
", page 342
⇒ "4.3 Removing and installing air flow mass meter G70 ",
page 343
⇒ "4.4 Check fuel pressure regulating valve N276 ", page 344
⇒ "4.5 Replace fuel pressure regulating valve N276 ", page 346
⇒ "4.6 Removing and installing fuel pressure sender G247 ", page
347
⇒ "4.7 Removing and installing differential pressure transmitter
G505 ", page 348
⇒ "4.8 Removing and installing pressure sensor for exhaust gas
1 G450 ", page 349
4.1 Removing and installing intake air tem‐
perature transmitter - G42- / charge air
temperature transmitter after charge air
cooler - G811-
Removing
– Remove engine cover
⇒ "1.1 Removing and installing engine trim panel", page 10
– Disconnect the electrical plug connection -1- or -2-.
1 - Charge air temperature transmitter after charge air cooler -
G811-
2 - Intake air temperature transmitter - G42-
– Unscrew the corresponding charge air temperature transmit‐
ter.
Install
Installation is performed in the reverse order, pay attention to the
following points:
• Tightening torque
⇒ "6.1 Assembly overview - intake manifold", page 355
4.2 Removing and installing fuel tempera‐
ture transmitter - G81-
Removing
– Remove engine cover
⇒ "1.1 Removing and installing engine trim panel", page 10
342
Rep. gr.23 - Mixture preparation - injection
.
.
.