– Pull sealing flange -3- slightly out of the fuel tank opening.
– Remove gasket ring -1- from fuel tank opening.
– Pull sealing flange -2- carefully out of the fuel tank opening.
Caution
There is a risk of fuel flowing out of the fuel delivery unit which
is still full.
♦ Put cleaning cloth underneath to collect fuel.
– Pull fuel delivery unit with sender for fuel gauge display - G-
carefully out of the fuel tank opening, turning and tilting as
appropriate.
Note
When removing the fuel delivery unit, ensure that the float arm of
the fuel gauge sender - G- is not bent.
Note
The old delivery unit must be emptied before disposing of it if
♦
it should be replaced.
You must be compliance with the environmental regulations
♦
when disposing of it.
Check fuel tank for contaminations.
♦
Install
Installation is carried out in the reverse order. Pay attention to the
following:
Note
Note the fitting position of all parts.
♦
Replace damaged gasket ring.
♦
When inserting the fuel delivery unit, ensure that the float arm
♦
of the fuel gauge sender - G- is not bent.
– Install new seal -1- for closing flange while dry.
– Coat inner side of gasket ring -1- with fuel.
– Insert fuel delivery unit with sender for fuel gauge display - G-
carefully through the fuel tank opening.
– Press down the closing flange against the spring force and
bring it into the installation position.
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
Octavia III 2013 ➤ , Octavia III 2014 ➤
2. Removing and installing parts of the fuel supply system
235