Skoda Octavia III 2013 Workshop Manual page 130

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
– Lightly oil sealing lip of the valve stem seal.
– Slide the valve stem seal onto the plastic bushing.
– Carefully press the valve stem seal with the valve stem seal
insertion tool - 3365- onto the valve guide.
– Remove plastic sleeve.
If the valve collets were removed from the assembly cartridge,
first of all they must be inserted into the insertion device for valve
collets -VAS 5161/18- .
• The large diameter of the valve collets points to the top.
– Insert the valve spring and the valve spring retainer.
– Press the assembly cartridge from the top onto the insertion
device for valve collets and lift up the valve collets.
– Re-insert the assembly cartridge into the guide plate -VAS
5161 A/31- .
– Press down the pressure fork and turn the knurled screw to
the left and to the right while pulling it upwards, by doing so
the valve collets are inserted.
– Release the pressure fork on tightened knurled screw.
– Repeat the procedure for each valve.
Assembling
Assembling is performed in the reverse order, while paying at‐
tention to the following:
– Ensure that all the roller arms are correctly positioned on the
valve stem ends and are clipped in place on the relevant hy‐
draulic balancing elements.
– Install camshaft housing
⇒ "2.6 Removing and installing camshaft housing",
page 114 .
– Install glow plugs
⇒ "1.2 Removing and installing glow plugs", page 421
2.8.2 Removing and installing valve stem
seals with cylinder head removed
Special tools and workshop equipment required
♦ Valve stem seal extractor - MP 1-230 (3364)-
♦ Valve stem seal fitting tool - MP 1-233 (3365)-
♦ Disassembly and assembly device for valve collets - VAS
5161- with guide plate -VAS 5161 A/31- and sleeve -VAS 5161
A/31-1-
♦ Engine and gearbox support - VAS 6095-
122
Rep. gr.15 - Cylinder head, valve gear
.