Removing And Installing The Front Bottom Coolant Pipe - Skoda Octavia III 2013 Workshop Manual

– Unclip bracket -1- with fuel hoses.
– Unscrew screws -arrows-.
– Loosen hose clamp -3-, remove coolant hose.
For vehicles with engine identification characters CLHA, CLHB,
CKFB, CKFC, CUPA, CRVC
– Unscrew screws -1-, -2-.
– Loosen hose clamps -arrows-, remove coolant hoses.
– Install the front top coolant pipes.
For vehicles with engine identification characters CRKB, CRMB,
CUNA
– Unscrew screws -1-, -2-.
– Loosen hose clamps -arrows-, remove coolant hoses.
– Install the front top coolant pipes.
Install
Installation is performed in a similar way in the reverse order. Pay
attention to the following points:
Note
Secure all hose connections with spring-type clips that comply
with the series design ⇒ ETKA - Electronic Catalogue of Original
Parts .
– Top up coolant ⇒ page 153
Tightening torques
♦ ⇒ "3.1 Summary of components - coolant pipe", page 170
♦ ⇒ "6.4 Summary of components - air filter", page 362
3.3 Removing and installing the front bottom
coolant pipe
Special tools and workshop equipment required
♦ Hose clip pliers - VAS 6362-
Removing
– Remove oil filter holder
⇒ "1.4 Removing and installing the oil filter holder with the en‐
gine oil cooler", page 132
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
.
.
Octavia III 2013 ➤ , Octavia III 2014 ➤
173
3. Coolant pipes