Skoda Octavia III 2013 Workshop Manual page 222

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
7 - Electrical plug connection
❑ for fuel system pressurisation pump - G6-
8 - Electrical plug connection
❑ for sender for fuel gauge display - G-
9 - Fuel return-flow line
❑ of engine
❑ pushed into the fuel tank
❑ do not kink
❑ to remove, press release button at connecting piece
❑ Unlock the quick coupling and disconnect
❑ observe the arrow direction (feed or return line) on the closing flange when installing
❑ Fit so that it can be heard clicking into place
❑ Press down again and check by pulling that the plug-in connector is fully engaged.
10 - Fuel gauge sender - G-
❑ Check resistance values
❑ removing and installing
2.2.2 Fuel delivery unit, vehicles with four-wheel drive - Summary of components
1 - Fuel delivery unit
❑ Equipment variant with‐
out auxiliary heating
system
❑ with fuel pump for pre‐
delivery - G6-
❑ removing and installing
⇒ "2.8 Removing and in‐
stalling fuel delivery
unit", page 232
❑ electrical testing of the
fuel pump in
Targeted
fault finding
cle diagnostic tester
❑ Fill the vehicle with at
least 5 litres of fuel after
installing
❑ Fitting position
⇒ page 211
2 - Fuel delivery unit
❑ Equipment variant with
auxiliary heating system
❑ with fuel pump for pre‐
delivery - G6-
❑ removing and installing
⇒ "2.8 Removing and in‐
stalling fuel delivery
unit", page 232
❑ electrical testing of the
fuel pump in
Targeted
fault finding
cle diagnostic tester
❑ Fill the vehicle with at
least 5 litres of fuel after
installing
214
Rep. gr.20 - Fuel supply system
⇒ "2.18 Check sender for fuel gauge display G ", page 285
⇒ "2.11 Removing and installing the sender for fuel gauge display ", page 245
⇒ Vehi‐
⇒ Vehi‐
⇒ "2.12 Separating push-on couplings", page 249 .