Skoda Octavia III 2013 Workshop Manual page 301

Caution
In case of mechanical damage to the exhaust gas turbocharg‐
er, e.g. damage of the compressor wheel, it is not sufficient to
only replace the exhaust gas turbocharger. In order to prevent
consequential damage to the engine, perform the following
tasks:
♦ Clean all oil lines.
♦ Change engine oil and oil filter.
♦ Check air filter housing, air filter element and charge air
pipes as well as charge air hoses for soiling.
♦ Check all the air guides and the charge air cooler for for‐
eign bodies.
If foreign bodies are detected in the charge air system, the
complete charge-air routing must be cleaned and if necessary
the charge air cooler must also be replaced.
Note
Observe rules for cleanliness
♦
⇒ "3.1 Rules of cleanliness", page 6
Observe general instructions for charge-air system
♦
⇒ "3 Repair instructions", page 6
Removing
Note
Fit all heat protection sleeves on again in the same place when
installing.
– Remove engine cover
⇒ "1.1 Removing and installing engine trim panel", page 10
– Remove the front silencer
⇒ "1.2 Removing and installing exhaust pipe", page 380
– Drain coolant ⇒ "1.2 Draining and filling coolant", page 151
– Remove rear coolant pipe
⇒ "3.7 Removing and installing the rear coolant pipe",
page 179 .
– Remove left coolant pipe
⇒ "3.6 Remove and install the left coolant pipes", page 178
Right-hand drive
– Remove exhaust gas cleaning module
– Continue for right-hand drive
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
.
.
⇒ page 392
⇒ page 296 .
Octavia III 2013 ➤ , Octavia III 2014 ➤
.
.
.
.
.
1. Charge-air system - exhaust gas turbocharger
293