Skoda Octavia III 2013 Workshop Manual page 349

– Mount the toothed belt pulley onto the hub.
• There must not be any oil present between the counterholder
and the toothed belt pulley
– Turn nuts -arrow- to the thread of the high pressure pump
shaft.
– Place counterholder on toothed belt pulley and tighten nuts
hand-tight -arrow-.
– Turn high pressure pump toothed belt pulley using the coun‐
terholder - T10051- until it can be locked with the rig pin -
T10492- .
– To do so, insert the rig pin -T10492- into fork -2- of the hub
and into the bore behind it -1- in the auxiliary units bracket.
– Loosen nuts -arrow- again.
• It must still be possible to just turn the high pressure pump
toothed belt pulley, however it must not hang loose.
– Installing the timing belt
⇒ "1.11 Removing and installing toothed belt", page 52
– Installing high pressure line
⇒ "2.9.2 Installing high pressure line", page 335
Caution
Risk of damage to the high pressure pump through running dry.
♦ If the high pressure pump is removed or replaced, the fuel
system must be filled/bled before the engine is started for
the first time
⇒ "1.3 Filling/bleeding the fuel system", page 321
– After replacing the high pressure pump, re-adjust the learning
values in "Targeted Functions" ⇒ Vehicle diagnostic tester.
Tightening torques
♦ ⇒ "3.1 Summary of components - high pressure pump", page
338
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
.
Octavia III 2013 ➤ , Octavia III 2014 ➤
.
.
341
3. High pressure pump