Skoda Octavia III 2013 Workshop Manual page 89

– Measure cylinder at 3 points crosswise in transverse direction
-A- and lengthwise -B-.
• Maximum deviation from nominal dimension: 0.10 mm.
– Check cylinder bore for wear of the honing surface, scratches
and other abnormalities.
Nominal dimen‐
sion
Note
Cylinder bores must not be measured when cylinder block is
mounted on engine and gearbox support - VAS 6095- , as meas‐
urements may be incorrect.
Fitting position of piston and assignment of piston to cylinder
Caution
Risk of damaging the piston crown.
♦ For re-installation, mark the assignment in colour on the
piston crown of cylinders that have already been used.
Piston crown not by centre punch, scratch, nick or similar
mark.
• Arrow on the piston crown to the belt pulley side -arrow-.
Installation position of the bearing shells in the conrods
– Insert bearing shells centrally in the conrod and conrod bear‐
ing cap.
• Dimension -a- = 2.5 mm
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
∅ cylinder mm
1.6 l
2.0 ltr.
Octavia III 2013 ➤ , Octavia III 2014 ➤
79,5
81,0
3. Crankshaft, Piston and Conrod
81