Removing And Installing Front Sealing Flange - Skoda Octavia 1996 Service Manual

OCTAVIA
Edition 12.99
S00.5105.52.20
Crank Assembly
Removing and installing front
sealing flange
Special tools, testers and aids required
♦ Torque wrench 5...50 Nm
(e.g. V.A.G 1331)
♦ Torque wrench 40...200 Nm
(e.g. V.A.G 1332)
♦ Locking lever T 30004 or counterholder MP
1-310
♦ Guide sleeve MP 1-314
♦ Hand drill with plastic brush attachment
♦ Silicone sealant D 176 404 A2
♦ Flat scraper
Removing
- Remove ribbed V-belt ⇒ page 13-1.
- Remove toothed belt ⇒ page 13-6.
K - Remove toothed belt sprocket of crankshaft.
Lock toothed belt sprocket with locking lever
T 30004 or counterholder MP 1-310 for this
step.
Note:
Place 2 washers between toothed belt sprocket
and counterholder when bolting on counter-
holder.
- Drain engine oil.
- Remove oil pan ⇒ page 17-3.
- Unbolt front sealing flange.
- Take off sealing flange; detach with light
blows from a rubber-headed hammer if
necessary.
- Remove sealant residues on cylinder block
with flat scraper.
K - Remove sealant residues on sealing flange
with rotating plastic brush (wear eye pro-
tection).
- Clean sealing surfaces; they must be free of
oil and grease.
13
------------ 13-17 ------------