Skoda Octavia III 2013 Workshop Manual page 256

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
– Unlock and detach the connector -3- at unit -2-.
– Thread out the electrical cables.
– Unlock the fuel gauge sender 2 - G169- -1- from the unit -2-.
To do so, carefully bend the guide lugs -arrows-.
– Detach the fuel gauge sender 2 - G169- in
-direction of arrow-.
Note
You must be compliance with the environmental regulations
♦
when disposing of it.
Check fuel tank for contaminations.
♦
Install
Installation is carried out in the reverse order. Pay attention to the
following:
Note
Note the fitting position of all parts.
♦
Replace damaged gasket ring.
♦
Correctly place the electrical lines into the uptakes.
♦
– Check the fuel gauge sender 2 - G169- for firm seating by
pulling in the opposite direction.
– Coat inner side of gasket ring -3- with fuel.
– Install the suction jet pump -1-.
Note
When inserting the fuel delivery unit 2 - G169- , ensure that the
float arm of the fuel gauge sender is not bent.
– Press the closing flange against the spring force and bring it
into the installation position.
248
Rep. gr.20 - Fuel supply system