Removing And Installing Exhaust Gas Turbocharger - Skoda Octavia III 2013 Workshop Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
27 - Ribbed bolt
❑ 14 Nm
28 - Gasket rings
❑ replace after removal
Bracket for exhaust gas cleaning module - tightening torques and
tightening order
– Bring holder to installation position.
– Tighten screws in steps in the specified sequence:
Stage Screws
1. -1-, -2-, -3-, -4- by hand as far as the stop
2. -2-
3. -1-
4. -3-, -4-
Exhaust gas turbocharger - tightening torque and tightening order
– Tighten screws in steps in the specified sequence:
Stage Screws
1. -Arrows-
2. -Arrows-
3. -Arrows-
1.2 Removing and installing exhaust gas
turbocharger
⇒ "1.2.1 Removing and installing exhaust gas turbocharger (en‐
gine identification characters CLHA, CLHB, CRKB, CKFB, CKFC,
CUPA, CRMB, CUNA)", page 292
⇒ "1.2.2 Removing and installing exhaust gas turbocharger (en‐
gine identification characters CRVC)", page 298
1.2.1 Removing and installing exhaust gas
turbocharger (engine identification char‐
acters CLHA, CLHB, CRKB, CKFB,
CKFC, CUPA, CRMB, CUNA)
Special tools and workshop equipment required
♦ Hose clip pliers - VAS 6362-
♦ Socket insert XZN 10 - T10501-
292
Rep. gr.21 - Turbocharging/supercharging
Tightening torque
20 Nm
40 Nm
40 Nm
Tightening torque
from inside to outside crosswise 11
Nm
from inside to outside crosswise 22
Nm
from inside to outside crosswise 22
Nm
• This measure takes account of the
settling behaviour of components