Skoda Octavia III 2013 Workshop Manual page 43

• A distance of -a- = 10 mm must be present between engine
support -2- and engine mount -1-.
• The cast edge on the engine support must be parallel with the
engine mount supporting arm.
• Dimension -b- = dimension -b-.
Note
The distance -a- = 10 mm can be checked, for example with suit‐
able round bars.
– Tighten engine mount screws.
Note
A gearbox mount with 2 screwed connections is shown as an ex‐
ample.
– Unscrew nut -arrow-, expose earth cable.
– Unscrew screws -arrows- for gearbox mount -1- after another
and replace (if not already done during engine installation).
– Initially, loosely insert the screws.
– Make sure that on the gearbox side the edges of the support‐
ing arm -1- and gearbox mount -2- are parallel.
• Dimension -x- = dimension -x-.
Installation is carried out in the reverse order.
Tightening torques
♦ ⇒ "2.1 Assembly overview - assembly mountings", page 29
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
Octavia III 2013 ➤ , Octavia III 2014 ➤
35
2. Assembly bracket