Skoda Octavia III 2013 Workshop Manual page 403

– Release screw -3-.
– Loosen hose clamps -1-, remove hoses.
– Press out pipeline -2- and remove the differential pressure
transmitter.
Continued for all vehicles
– Open hose clamp -1-, remove coolant hose.
– Unscrew screws -2- and -3- and swivel coolant line to the side.
Vehicles fitted with auxiliary heating
– Raise holding clamps -1- and undo hose clamp -3-, remove
coolant hoses.
– Release nuts -arrows-, remove coolant pipe.
Vehicles with four-wheel drive
– Unscrew the right driveshaft from the angle gearbox ⇒ Sus‐
pension; Rep. gr. 40 and tie up towards the rear.
– Release screws -arrows- and remove heat shield -1-.
– To reinstall, mark the position of the flexible disk and the angle
gearbox flange to each other.
– Unscrew the propshaft from the angle gearbox -arrows-, while
counterholding with a lever on the triangular flange.
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
Octavia III 2013 ➤ , Octavia III 2014 ➤
2. Cleansing exhaust emissions
395