Skoda Octavia III 2013 Workshop Manual page 73

1 - Screw
❑ replace after removal
❑ 60 Nm + torque a further
1
90° ( / 4 turn)
2 - Flywheel
❑ Inspect proper opera‐
tion of two-mass fly‐
wheel ⇒ Vehicle diag‐
nostic tester
❑ removing and installing
⇒ "2.5 Removing and in‐
stalling flywheel",
page 73
❑ can be installed only in
one position
❑ Observe part number ⇒
ETKA - Electronic Cata‐
logue of Original Parts
3 - Rotor
❑ for engine speed trans‐
mitter - G28-
❑ removing and installing
⇒ "2.4 Removing and in‐
stalling sealing flange
on gearbox side",
page 66
4 - Engine speed transmitter -
G28-
❑ Summary of compo‐
nents
⇒ "1.1 Summary of com‐
ponents - preheating
system ", page 420
5 - Screw
❑ 4.5 Nm
6 - Fit pin
❑ Qty. 2
7 - Intermediate plate
❑ do not damage or bend during assembly work
❑ installing ⇒ page 66
8 - Sealing flange on the gearbox side
❑ with gasket ring
❑ replace after removal
9 - Bolt
❑ Tightening torque and tightening order
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
⇒ "2.4 Removing and installing sealing flange on gearbox side", page 66
⇒ page 66
Octavia III 2013 ➤ , Octavia III 2014 ➤
2. Removing and installing sealing flange and flywheel
65