Skoda Octavia III 2013 Workshop Manual page 145

Note
Pay attention to the use by date on sealant.
– Cut off nozzle tube at the front marking (∅ of nozzle approx.
2 ... 3 mm).
Caution
There is risk of blockage of the lubrication system through ex‐
cess sealant.
Do not apply thicker sealant strips than indicated.
When the sealing flange on the belt pulley side was not replaced
Note
The bottom surface of the sealing flange on the belt pulley side
has a displacement of approx. 1 mm to the bottom cylinder block
surface after removing the old silicone seal, which must be com‐
pensated for by applying the required sealant on the correspond‐
ing area of the oil pan sealing surface.
– Apply sealant bead onto the clean sealing surfaces of the oil
sump, as shown in the illustration.
♦ In the area of the sealing surface of the sealing flange on the
belt pulley side between -arrows-: 3 ... 4 mm
♦ In the area of the sealing surfaces of the cylinder block and
the sealing flange on the gearbox side: 2 ... 3 mm
• The sealant strips must be replaced in the area of the sealing
flange on the belt pulley side with the sealant bead equal to
the height and width of the silicone seal.
Note
After applying the sealant, the oil separator must be installed
within 5 minutes.
When the sealing flange on the belt pulley side was not replaced
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
Octavia III 2013 ➤ , Octavia III 2014 ➤
1. Removing and installing parts of the lubrication system
137