Mixture Preparation - Injection; Diesel Direct Injection System - Fitting Location, System Overview; Installation Location Overview - Fuel Injection System - Skoda Octavia III 2013 Workshop Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
23 –

Mixture preparation - injection

1 Diesel direct injection system - fitting
location, system overview
⇒ "1.1 Installation location overview - fuel injection system", page
314
⇒ "1.2 Schematic overview - fuel system", page 320
⇒ "1.3 Filling/bleeding the fuel system", page 321
⇒ "1.4 Check the fuel system for tightness", page 322
1.1 Installation location overview - fuel in‐
jection system
⇒ "1.1.1 Installation location overview - engine compartment",
page 314
⇒ "1.1.2 Installation location overview - engine from left",
page 317
⇒ "1.1.3 Installation location overview - engine from right",
page 319
1.1.1 Installation location overview - engine
compartment
The control unit is equipped with a fault memory. Before repairs,
setting operations and fault finding, interrogate the fault memory
and execute a self-diagnosis ⇒ Vehicle diagnostic tester.
Note
Faults can be detected by the control unit as checking and
♦
adjustment work is being undertaken and then saved. It is
therefore absolutely necessary to delete the fault memory af‐
ter completing all checking and adjustment work ⇒ Vehicle
diagnostic tester
Observe the safety precautions when working on the diesel
♦
direct injection system
314
Rep. gr.23 - Mixture preparation - injection
⇒ "2 Safety instructions", page 3 .