Octavia III 2013 ➤ , Octavia III 2014 ➤
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
Removing
Note
Fit all cable straps on again in the same place when installing.
♦
When removing, the electric cable must be not cut off, since
♦
doing so would mean that fault diagnosis would no longer be
possible.
– Remove engine cover
⇒ "1.1 Removing and installing engine trim panel", page 10
– Open heat protection sleeve.
– Take electrical plug connection-1 - out of the holder, discon‐
nect and expose electric wiring loom.
– Unscrew exhaust gas temperature transmitter 1 - G235- Po‐
sition -2- using extension SW 17 - V.A.G 1331/10- .
Install
Installation is performed in the reverse order, pay attention to the
following points:
Note
Protect exhaust gas temperature transmitter from impacts and
♦
shocks: Do not use any exhaust gas temperature transmitter
that has been dropped.
Coat threads with hot bolt paste; hot bolt paste ⇒ ETKA -
♦
Electronic Catalogue of Original Parts .
Fitting position of the exhaust gas temperature transmitter -
G235- :
•
Angled shank -1- downwards horizontally.
– Electrical connections and proper routing ⇒ Electrical System;
Rep. gr. 97 and ⇒ Current flow diagrams, Electrical fault find‐
ing and Fitting locations.
Tightening torques
♦
⇒ "3.1 Summary of components - exhaust temperature regu‐
lation", page 402
3.2.2
Remove and install exhaust gas tem‐
perature transmitter 3 - G495- / exhaust
gas temperature transmitter 4 - G648-
Special tools and workshop equipment required
♦ Set of tools - T10395-
404
Rep. gr.26 - Exhaust system
.