Checking And Adjusting The Assembly Bracket - Skoda Octavia III 2013 Workshop Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
2.6 Checking and adjusting the assembly
bracket
Checking the assembly bracket
Work procedure
The following dimensions must be reached:
• A distance of -a- = 10 mm must be present between engine
support -2- and engine mount -1-.
• The cast edge on the engine support must be parallel with the
engine mount supporting arm.
• Dimension -b- = dimension -b-.
Note
The distance -a- = 10 mm can be checked, for example with suit‐
able round bars.
– If the measured distance is too great or too small, adjust the
assembly bracket ⇒ page 34
Adjusting the assembly bracket
Work procedure
– Support the engine in its installed position
⇒ "2.2 Support the engine in its installed position", page 31
– Slightly pre-tension engine/gearbox unit with the spindle -
MP9-200/10- , do not raise.
– Unscrew screws -arrows- for engine mount one after another
and replace (if not already done during engine installation).
– Initially, loosely insert the screws.
– Move engine/gearbox unit with an assembly lever until the fol‐
lowing dimensions are set:
34
Rep. gr.10 - Removing and installing engine
.
.