Removing And Installing Fuel Delivery Unit - Skoda Octavia III 2013 Workshop Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
– Carefully remove the closing flange -2- on the left together with
the suction jet pump -1- from the fuel tank opening a little.
– Insert suction hose of fuel extractor - VAS 5190- as far as
possible into fuel tank.
– Extract fuel using the fuel extraction device - VAS 5190- .
When only emptying the fuel tank:
– Reinstall the fuel delivery unit
⇒ "2.8 Removing and installing fuel delivery unit", page 232
– Install the fuel gauge sender 2 - G169- again
⇒ "2.11 Removing and installing the sender for fuel gauge dis‐
play ", page 245 .
Tightening torques
♦ ⇒ "2.2 Fuel delivery unit - Summary of components",
page 212
♦ ⇒ Heating, Air conditioning; Rep. gr. 82
2.8 Removing and installing fuel delivery
unit
⇒ "2.8.1 Removing and installing the fuel delivery unit, vehicles
with front-wheel drive ", page 232
⇒ "2.8.2 Removing and installing the fuel delivery unit, vehicles
with four-wheel drive ", page 236
2.8.1 Removing and installing the fuel delivery
unit, vehicles with front-wheel drive
Special tools and workshop equipment required
♦ Disassembly wedge - 3409-
♦ Key - T30101 (3087)-
Precondition
•
The fuel tank must not be more than
Removing
Note
If necessary drain the fuel tank
♦
⇒ "2.7 Extract fuel from the fuel tank", page 223
Safety precautions when working on the fuel supply system
♦
⇒ "2 Safety instructions", page 3
♦ Observe rules for cleanliness
⇒ "3.1 Rules of cleanliness", page 6
– Move front seats all the way forward.
– Switch off ignition.
– Removing rear seat bench ⇒ Body Work; Rep. gr. 72 .
232
Rep. gr.20 - Fuel supply system
1
/ 3 full.
.
.
.
.