Skoda Octavia III 2013 Workshop Manual page 244

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
– The peg -2- at the closing flange -1- must be located against
arrow -3- at the fuel tank.
Caution
Risk of leakage.
♦ The gasket ring must not get damaged or squashed when
inserting the sealing flange.
Note
Ensure that the fuel delivery unit is not damaged when tightening
the lock ring of the holder on the flange.
– Insert lock ring and tighten using the wrench - T30101 (3087)- .
– Fit fuel lines -1- and -2- so that they can be heard clicking into
place.
– If present, install the fuel line -3- for the dosing pump of the
auxiliary heating - V54- at the closing flange ⇒ Heating, Air
Conditioning; Rep. gr. 82 .
– Press fuel lines down again and check by pulling that the plug-
in connector is fully engaged.
– Connect connectors -1- and -2-.
– If present, unhook the electrical plug connection -3- for dosing
pump of the auxiliary heating - V54- on the closing flange.
– Check the connector for firm seating by pulling in the opposite
direction!
– After installing the fuel delivery unit, refuel the vehicle with at
least 5 litres of fuel.
Tightening torques
♦ ⇒ "2.2 Fuel delivery unit - Summary of components",
page 212 .
2.8.2 Removing and installing the fuel delivery
unit, vehicles with four-wheel drive
Special tools and workshop equipment required
236
Rep. gr.20 - Fuel supply system