Skoda Octavia III 2013 Workshop Manual page 343

– Release screw -1-.
– Unscrew union nuts -arrows- and remove high pressure line.
2.9.2 Installing high pressure line
Special tools and workshop equipment required
♦ Tool insert SW 17
♦ Socket wrench insert - T40055-
Note
Safety precautions when working on the fuel supply system
♦
⇒ "2 Safety instructions", page 3
♦ Observe rules for cleanliness
⇒ "3.1 Rules of cleanliness", page 6
Work procedure
Note
Clean fuel line and line end with cold cleaner before removal,
♦
and blow dry with compressed air.
Pay attention to the cylinder specific marking when re-using
♦
the high pressure lines.
The high pressure lines can be re-used after the following
♦
tests:
Check the sealing cone of the respective high pressure line for
♦
deformations and cracks.
The line borings must not be deformed, constricted or dam‐
♦
aged.
Corroded lines must no longer be used.
♦
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
.
.
Octavia III 2013 ➤ , Octavia III 2014 ➤
2. Injection units/fuel distributor
335