Removing And Installing The Sealing Flange On The Belt Pulley Side - Skoda Octavia III 2013 Workshop Manual

Sealing flange on the belt pulley side - tightening torque and tight‐
ening order
– Tighten screws in steps in the given sequence:
Stage Screws
1. -1 ... 10-
2. -1 ... 6-
3. -7 ... 10-
2.2 Removing and installing the sealing
flange on the belt pulley side
Special tools and workshop equipment required
♦ Counterholder - T30004 (3415)- or counterholder for toothed
belt sprocket - MP 1-310 (3099)-
♦ Assembly tool - T10053-
♦ Protective goggles and gloves
♦ Sealant remover gasket stripper (bearing code GST, bearing
article no. R 34402), manufacturer Retech s.r.o.
♦ Cleaning and degreasing agent , e.g. -D 009 401 04-
♦ Silicone sealant ⇒ ETKA - Electronic catalogue of original
parts
Removing
– Remove the front right wheelhouse liner ⇒ Body Work; Rep.
gr. 66 .
– Removing toothed belt
⇒ "1.11 Removing and installing toothed belt", page 52
– Remove crankshaft - toothed belt sprocket, to this end lock
toothed belt sprocket with counterholder - T30004 (3415)- or
counterholder - MP 1-310- .
– Removing the oil pan
⇒ "1.5 Removing and installing oil sump", page 135
– Unscrew the remaining screws and carefully loosen the seal‐
ing flange from the bonding.
Install
Install in the reverse order of removal. When doing this, note the
following:
WARNING
Wear protective gloves when working with sealant and grease
remover!
– Remove residual sealant from the sealing surfaces on sealing
flange, cylinder block and on the oil pan with chemical sealant
remover.
– Degrease the sealing surfaces.
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
Tightening torque
by hand as far as the stop
crosswise in steps up to 13 Nm
13 Nm
Octavia III 2013 ➤ , Octavia III 2014 ➤
.
.
2. Removing and installing sealing flange and flywheel
63