Removing And Installing The Sealing Flange On The Gearbox Side - Skoda Octavia III 2013 Workshop Manual

– Position the flywheel lock - MP1-504- on the starter ring gear
of the flywheel and turn crankshaft until the lock rests against
the sleeve - T30010 - .
Continued for all engines
– Rotate the secondary side -A- of the two-mass flywheel in such
a way that the screws -B- are positioned in the middle of the
holes -arrows-.
Caution
When unscrewing the screws -B-, ensure that no screw head
catches on the secondary side -A- of the two-mass flywheel,
otherwise the flywheel will be damaged.
♦ When unscrewing screws, ensure that no screw head is
present on the flywheel.
– Release screws -B- and remove two-mass flywheel.
Install
Installation is carried out in the reverse order. However, pay at‐
tention to the following:
Note
Use new screws for attaching.
– Rotate the secondary side -A- of the two-mass flywheel in such
a way that the screws -B- are positioned in the middle of the
holes -arrows-.
1. Screw in all the screws -B- by hand.
2. First of all tighten all the screws -B- crosswise to 60 Nm.
3.
Then torque all the screws -B- crosswise a further 90° (
turn.)
2.3 Removing and installing the sealing
flange on the gearbox side
Special tools and workshop equipment required
♦ Cleaning and degreasing agent , e.g. -D 009 401 04-
♦ Sealant remover gasket stripper (bearing code GST, bearing
article no. R 34402), manufacturer Retech s.r.o.
♦ Silicone sealant ⇒ ETKA - Electronic catalogue of original
parts
Octavia III 2013 ➤ , Octavia III 2014 ➤
1.8/132 kW TSI; 2.0/162 kW TSI engines - Edition 01.2015
1
/ 4
2. Cylinder block - gearbox end
57