Skoda Octavia III 2013 Workshop Manual page 67

• The locking point of the hub of the high pressure pump is al‐
ways difficult to find again. A slight difference -arrow- does not
influence the engine running.
• The tensioning pulley pointer -2- must be positioned in the
centre between the pegs -1- and -3- of the base plate.
Note
A lateral offset of a maximum of 5 mm is permitted.
If the conditions are met, continue if timing is set correctly
⇒ page 60 .
If the conditions are not met, correct timing
Correct timing
– If the hub of the camshaft cannot be locked, pull back the
crankshaft arrester - T10490- until the stud disconnects from
the bore.
– Turn the crankshaft slightly against the running direction of the
engine over the "TDC".
– Now turn the crankshaft slowly in the running direction of the
engine until the hub of the camshaft can be locked.
– After locking, loosen camshaft toothed belt pulley screws.
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
⇒ page 59
Octavia III 2013 ➤ , Octavia III 2014 ➤
.
1. Removing and installing a V-ribbed belt and a toothed belt
59