Skoda Octavia III 2013 Workshop Manual page 332

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
❑ fill/bleed fuel system af‐
ter exchange ⇒ "1.3 Filling/bleeding the fuel system", page 321
7 - Clamping claw
Caution
Risk of engine damage!
♦ When installing a new
stripped engine and after
fitting the high pressure
lines, it is absolutely nec‐
essary to tighten the
clamping claws of the in‐
jection units to the speci‐
fied tightening torque
Pos. -8-
⇒ Item 8 (page 324)
order to align the injec‐
tion units when fitting the
high pressure lines, the
clamping claws are only
tightened in series »by
hand«.
❑ removed injection units and clamping claws to be re-installed must only be mounted again at the same
cylinder.
❑ Fitting position ⇒ page 324
8 - Screw
❑ replace after removal
❑ 9 Nm + torque a further 180° (
9 - High pressure line
❑ between fuel distributor and injection units
❑ follow all instructions for installation of high pressure lines
⇒ "2.9.2 Installing high pressure line", page 335
❑ install free of stress
❑ 28 Nm
10 - Grommet
❑ in the cylinder head cover
❑ replace if damaged.
Fitting position of the clamping claw
• One clamping claw has 2 injection units.
• The clamping claw gasket -arrow- points downwards.
324
Rep. gr.23 - Mixture preparation - injection
. In
1
/ 2 turn)
.