Skoda Octavia III 2013 Workshop Manual page 79

C - Bolt assembly tool - T10134- onto the crankshaft flange:
– Move the assembly cup -C- by hand in the
-direction of the arrow- until the sealing lip supporting ring
-B- rests on the crankshaft flange -A-.
Caution
Risk of mix-ups.
♦ The guide pin for petrol engines -F- must not be inserted
in threaded hole of crankshaft.
– Push guide pin for diesel engines -D- into the crankshaft bore;
this puts the rotor into the final installation position.
– Tighten both hexagon socket head bolts of the assembly de‐
vice by hand.
– Screw hexagon nut -E- onto threaded spindle by hand until it
lies against assembly housing -C-.
D - Press sender wheel onto crankshaft flange using assembly
device - T10134-
– Tighten hexagon nut for the assembly device - T10134- to 35
Nm.
• After hexagon nut is tightened to 35 Nm, a small air gap must
still be present between cylinder block and sealing flange.
E - Inspect the installation position of the rotor on the crankshaft
– Screw in hexagon nut -E- up to the end of the threaded spindle.
– Release screws -A- from the cylinder block.
– Release knurled screws -B- from the sealing flange.
– Unscrew hexagon socket head bolts.
– Unscrew assembly device - T10134- from the crankshaft
flange - to do so, unscrew the hexagon socket head bolts from
the crankshaft flange.
– Remove assembly tool - T10134- .
– Remove sealing lip support ring.
– Mount depth gauge - VAS 6082- onto the crankshaft flange.
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
Octavia III 2013 ➤ , Octavia III 2014 ➤
2. Removing and installing sealing flange and flywheel
71