Skoda Octavia III 2013 Workshop Manual page 379

1 - Gasket
❑ replace after removal
❑ Check fitting position
⇒ page 372
2 - Clamping sleeve
❑ replace
❑ Fitting position
⇒ page 372
❑ 7 Nm
3 - Pre-exhaust pipe
❑ removing and installing
⇒ "1.2 Removing and in‐
stalling exhaust pipe",
page 380
❑ ustawienie układu wy‐
dechowego bez naprę‐
żeń
⇒ "1.6 Aligning exhaust
system free of stress",
page 386
❑ Observe part number ⇒
ETKA - Electronic Cata‐
logue of Original Parts
4 - Support
❑ replace if damaged
5 - Screw
❑ 23 Nm
6 - Exhaust flap control unit -
J883-
❑ removing and installing
⇒ "1.3 Removing and in‐
stalling the exhaust flap
control unit J883 ", page
381
7 - Front clamping sleeve
❑ before tightening, align exhaust system free of stress
⇒ "1.6 Aligning exhaust system free of stress", page 386
❑ Fitting position ⇒ page 372
❑ Tighten bolted connections evenly
❑ 30 Nm
8 - Retaining strap
❑ replace if damaged
9 - Hanger
❑ replace if damaged
10 - Nut
❑ 20 Nm
11 - Rear tunnel bridge
12 - Front tunnel bridge
13 - Middle and rear silencer
❑ for first equipment a building unit, replace individually when carrying out repairs
⇒ "1.5 Replacing middle or rear silencer", page 385
❑ ustawienie układu wydechowego bez naprężeń
⇒ "1.6 Aligning exhaust system free of stress", page 386
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
Octavia III 2013 ➤ , Octavia III 2014 ➤
1. Removing and installing exhaust pipes/silencers
371