Summary Of Components - Gearbox Side Summary Of Components And Flywheel - Skoda Octavia III 2013 Workshop Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
– Install -T10053/1- guide bushing on the crankshaft stub.
Note
Pay attention to the use by date on sealant.
– Cut off nozzle on tube at front marking (∅ of nozzle approx. 2
mm).
– Apply sealant bead -arrow- onto the clean sealing surface of
the sealing flange, as shown in the illustration.
• Thickness of sealant bead: 2 ... 3 mm.
Note
The sealant bead must not be thicker than 3 mm otherwise
♦
excess sealant may get into the oil pan and clogg the strainer
in the oil suction pipe.
The sealing flange must be installed within 5 minutes after ap‐
♦
plying the sealant.
– Slide new sealing flange over the guide sleeve.
• The fit pins will engage with the bores in the cylinder block
during this process.
– Remove guide bushing.
– Tighten sealing flange screws
– Installing the oil pan
⇒ "1.5 Removing and installing oil sump", page 135
– install (set the timing)
Tightening torques
♦ ⇒ Fig. ""Sealing flange on the belt pulley side - tightening tor‐
que and tightening order"" , page 63
♦ ⇒ "1.7 Assembly overview - toothed belt drive", page 44
♦ Summary of components - front wheelhouse liner ⇒ Body
Work; Rep. gr. 66
2.3 Summary of components - gearbox side summary of components and fly‐
wheel
64
Rep. gr.13 - Crankshaft group
⇒ page 63 .
⇒ page 54 .
.