– Push the rear silencer so far forward until the pre-tensioning
on the retaining strap on the exhaust pipe is -a- = 5 mm.
– Install clamping sleeve in the angle position shown.
•
Vehicles with front-wheel-drive: Angle -α- = approximately 20°.
•
Vehicles with four-wheel drive: Angle -α- = approximately 50°.
•
Bolted connection to the right.
•
Nuts upwards.
– Tighten bolted connections of clamping sleeve evenly to 30
Nm.
1.7
Align exhaust tailpipes
– Align rear silencer in such a way that there is an equal distance
-a- and -b- between bumper opening and exhaust tailpipes.
– For centering the exhaust tailpipes, if necessary loosen the
suspension of the rear silencer.
1.8
Inspecting the exhaust system for leak‐
tightness
– Start engine and run at idling speed.
– Close off exhaust tailpipes for the duration of the leak test, for
example using cloths or plugs.
– Check connection points for leaktightness by listening: ex‐
haust manifold at cylinder head, exhaust gas turbocharger at
pre-exhaust pipe, etc.
– Eliminate any leak found.
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
Octavia III 2013 ➤ , Octavia III 2014 ➤
1. Removing and installing exhaust pipes/silencers
387