Octavia III 2013 ➤ , Octavia III 2014 ➤
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
– Loosen clips -arrows-, remove noise insulation -1- for oil sump.
Vehicles with four-wheel drive
– To reinstall, mark the position of the flexible disk and the angle
gearbox flange to each other.
– Unscrew the propshaft from the angle gearbox -arrows-, while
counterholding with a lever on the triangular flange.
– Push engine/gearbox assembly slightly forward (towards the
front of the body) and then pull off the propshaft from the angle
gearbox.
Caution
Risk of damage to the gasket ring -arrow- in the flange of the
propshaft.
Push propshaft horizontally as far back and towards the right
vehicle side as possible.
Note
In case of damaged gasket ring the propshaft must be replaced.
Continued for all vehicles
22
Rep. gr.10 - Removing and installing engine