Skoda Octavia III 2013 Workshop Manual page 303

– Open heat protection sleeve -1-.
– Take electrical plug connection-5 - out of the holder, discon‐
nect and expose electric cable.
– Disconnect electrical plug connections -3-, -6-, expose electric
wiring loom.
For vehicles with engine identification characters CRKB, CRMB,
CUNA
– Separate electrical plug connection -4-.
Continued for left-hand drive vehicles
– Unscrew screw -2-, lay bracket with differential pressure trans‐
mitter - G505- to the rear.
– Loosen hose clamp -1-, remove coolant hose.
– Unscrew screw -2-, remove screw -3- and swivel coolant line
to the side.
– Expose the following plug connections and electric cables:
1 - for exhaust gas temperature transmitter 4 - G648-
2 - for exhaust gas temperature transmitter 3 - G495-
3 - for exhaust gas temperature transmitter 2 - G448- for vehicles
with engine identification characters CRKB, CRMB, CUNA
– Take electrical plug connection-4- for lambda probe - G39- out
of the holder, disconnect and expose electric cable.
Vehicles fitted with auxiliary heating
– Raise holding clamp -1- and loosen hose clamp -3-, remove
coolant hoses.
– Release nuts -arrows-, remove coolant pipe.
Continued for left-hand drive vehicles
Caution
When pressing out the exhaust gas cleaning module, take ac‐
count of electric cable of exhaust gas temperature transmitter
1 - G235- -1-!
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
Octavia III 2013 ➤ , Octavia III 2014 ➤
1. Charge-air system - exhaust gas turbocharger
295