Skoda Octavia III 2013 Workshop Manual page 310

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
– Unscrew nuts -arrows- and detach the exhaust gas turbo‐
charger with exhaust manifold from the cylinder head, and
remove from the top.
Install
Install in the reverse order of removal. When doing this, note the
following:
Note
Replace gasket rings, gaskets, O-rings and the self-locking
♦
nuts after disassembly.
Fill the exhaust turbocharger with engine oil at the connection
♦
fitting for the oil feed line.
Hose connections and air guide pipes and hoses must be free
♦
of oil and grease before being installed.
Secure all hose connection ends with spring-type clips that
♦
comply with the series design ⇒ ETKA - Electronic Catalogue
of Original Parts .
To ensure the oil supply to the exhaust gas turbocharger,
♦
leave the engine running for about 1 minute after installing the
exhaust gas turbocharger; do not rev up immediately.
– Electrical connections and proper routing ⇒ Electrical System;
Rep. gr. 97 and ⇒ Current flow diagrams, Electrical fault find‐
ing and Fitting locations.
– Install the rear coolant pipe
⇒ "3.7 Removing and installing the rear coolant pipe",
page 179 .
– Install mounting bracket for radiator for exhaust gas recircu‐
lation ⇒ page 412 .
– Install radiator for exhaust gas recirculation
⇒ "4.5 Removing and installing radiator for exhaust gas recir‐
culation", page 415
– Install high catalytic converter
⇒ "2.3 Removing and installing catalytic converter",
page 400 .
– Install pre-exhaust pipe
⇒ "1.2 Removing and installing exhaust pipe", page 380
– Connect vacuum hose
⇒ "1.4 Connection diagram for vacuum hoses", page 306
Tightening torques
♦ ⇒ "1.1 Exhaust gas turbocharger with component parts - Sum‐
mary of components", page 290
♦ ⇒ "2.1 Summary of components - exhaust gas cleaning", page
388
1.3 Replace vacuum positioning element for
charge pressure regulation with position
sender for charge pressure regulator -
G581-
Special tools and workshop equipment required
♦ Hand vacuum pump - VAS 6213-
302
Rep. gr.21 - Turbocharging/supercharging
.
.
.