Skoda Octavia III 2013 Workshop Manual page 391

– Loosen the clamping sleeve -2- and slide it forwards.
– Unscrew screws -arrows-, remove middle silencer.
Install
Installation is performed in the reverse order, pay attention to the
following points:
Note
Replace gasket.
– Observe the rear and front installation position of clamping
plate
⇒ "1.1 Summary of components - front, middle and rear si‐
lencer", page 370
– Align exhaust system free of stress
⇒ "1.6 Aligning exhaust system free of stress", page 386
Tightening torques
♦ ⇒ "1.1 Summary of components - front, middle and rear si‐
lencer", page 370
1.4.2 Removing and installing rear silencer,
vehicles with front-wheel drive (engine
identification characters CUPA, CUNA)
Removing
– Vehicles without separation point Replace middle or rear si‐
lencer ⇒ "1.5 Replacing middle or rear silencer", page 385
– Vehicles with separation point: Unhook suspension -3- from
the rear silencer.
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
Octavia III 2013 ➤ , Octavia III 2014 ➤
.
.
1. Removing and installing exhaust pipes/silencers
383