Removing And Installing Catalytic Converter - Skoda Octavia III 2013 Workshop Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
– Connect hoses, fit hose clamps -1-.
– Tighten screw -3-, Pos. -4-
⇒ "1.6 Summary of components - toothed belt guard",
page 42 .
– Screw on holder for differential pressure transmitter to cylinder
head cover, Pos. -5-
⇒ "1.1 Assembly overview - cylinder head cover", page 85
– Install the assembly carrier ⇒ Chassis; Rep. gr. 40 .
– After replacing the exhaust gas cleaning module, reset the
learning values⇒ Vehicle diagnostic tester,
,
tions Resetting learning values
2.3 Removing and installing catalytic con‐
verter
For vehicles with engine identification characters CRVC
Removing
– Remove the sound dampening systems and tunnel cover ⇒
Body Work; Rep. gr. 50 .
– Undo the screws of the clamping sleeve -2-, leave the clamp‐
ing sleeve in the fitting position.
– Open clamp -1- and remove.
– Unscrew the screws -3-, slide the clamping sleeve -2- to the
rear and remove the pre-exhaust pipe -A-.
– Unscrew the fixing nuts -1-, undo the screws -2- by a quarter
turn.
– Remove engine cover
⇒ "1.1 Removing and installing engine trim panel", page 10
400
Rep. gr.26 - Exhaust system
.
Targeted Func-
.
.