Removing And Installing Charge Air Cooler Pump V188 - Skoda Octavia III 2013 Workshop Manual

– Separate electrical plug connection -1-.
– Unscrew double screw -2-, remove coolant temperature trans‐
mitter - G62- .
Note
Use a wire to pull out any O-ring or distance ring that has re‐
mained stuck inside the cylinder head.
Install
Installation is performed in the reverse order, pay attention to the
following points:
Note
Replace O-rings.
♦
Replace distance ring if it is damaged.
♦
– Install the left coolant pipe
⇒ "3.6 Remove and install the left coolant pipes", page 178
– Check coolant level
Tightening torques
♦ ⇒ "1.4 Summary of components - cylinder head", page 90
♦ ⇒ "6.4 Summary of components - air filter", page 362
♦ ⇒ "6.1 Assembly overview - intake manifold", page 355
♦ Summary of components - gearshift mechanism ⇒ Gearbox;
Rep. gr. 34
2.9 Removing and installing charge air cool‐
er pump - V188-
Special tools and workshop equipment required
♦ Hose clamps up to ∅ 25 mm - MP7-602 (3094)-
♦ Hose clip pliers - VAS 6362-
Removing
– Remove the sound dampening system ⇒ Body Work; Rep.
gr. 50 .
Vehicles with charge air cooler pump - V188- Version 1
– Separate electrical plug connection -3-.
Note
Place a cloth below to catch any leaking coolant.
– Disconnect coolant hoses with hose clamps -MP7-602
(3094)- .
– Loosen hose clamps -2-, remove coolant hoses.
– Unhook charge air cooler pump - V188- Pos. -1- out of the
retaining strap -4-.
Vehicles with charge air cooler pump - V188- Version 2
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
⇒ page 156 .
Octavia III 2013 ➤ , Octavia III 2014 ➤
.
2. Coolant pump and coolant thermostat
167