Skoda Octavia III 2013 Workshop Manual page 425

– Mount hose -2- on radiator -1- for exhaust gas recirculation.
• Fitting position: Marking "EGR side" -arrow- points to the ex‐
haust gas recirculation radiator.
– Ensure that the air guide hose fitting is free of tension.
– Position radiator -1- for exhaust gas recirculation on the ex‐
haust gas cleaning module with gasket and gripper clamp.
– Turn radiator for exhaust gas recirculation in anticlockwise di‐
rection -arrow- and simultaneously put hose -3- onto the ex‐
haust gas turbocharger-2-.
– Bring gripper clamp -3- to installation position
– Tighten screw connections
– Install the left coolant pipe
⇒ "3.6 Remove and install the left coolant pipes", page 178
Tightening torques
♦ ⇒ Fig. ""Radiator for exhaust gas recirculation - tightening tor‐
ques and tightening order"" , page 410
♦ ⇒ "1.1 Summary of components - front, middle and rear si‐
lencer", page 370
4.5.2 Removing and installing radiator for ex‐
haust gas recirculation (engine identifi‐
cation characters CRVC)
Special tools and workshop equipment required
♦ Socket insert - T10347-
♦ Socket insert XZN 10 - T10501-
♦ Set of tools - T10395 A-
Removing
– Remove catalytic converter
⇒ "2.3 Removing and installing catalytic converter",
page 400 .
– Drain coolant ⇒ "1.2 Draining and filling coolant", page 151
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
⇒ page 410
⇒ page 410 .
Octavia III 2013 ➤ , Octavia III 2014 ➤
.
.
.
4. Exhaust gas recirculation system
417