Octavia III 2013 ➤ , Octavia III 2014 ➤
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
Note
For vehicles with torsion beam rear axle, a disconnection is
♦
provided in the exhaust pipe to facilitate removal of the ex‐
haust system.
The separation point is marked by indentation on the circum‐
♦
ference of the exhaust pipe.
Work procedure
WARNING
To avoid injury from metal shavings, wear eye protection and
protective clothing.
– Separate exhaust pipe at right angles at the separation point
-arrow 2-.
– When installing, position clamping sleeve -4- at the side mark‐
ings arrow -1- and arrow -3-.
– Note installation position of clamping sleeve
⇒ "1.1 Summary of components - front, middle and rear si‐
lencer", page 370
.
– Align exhaust system free of stress
⇒ "1.6 Aligning exhaust system free of stress", page 386
– Tighten bolted connections of warm-type clamp evenly to 30
Nm.
•
The bolted connection points to the left.
1.6
Aligning exhaust system free of stress
•
The exhaust system is aligned when cold.
– Slacken bolted connections of clamping sleeve -2-.
386
Rep. gr.26 - Exhaust system
.