Skoda Octavia III 2013 Workshop Manual page 34

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
– If there are no dowel sleeves -A- are available in the cylinder
block for centering the engine and gearbox, insert dowel
sleeves.
Note
A vehicle with manual gearbox is shown as an example.
Vehicles fitted with a manual gearbox
– If a needle bearing is installed in the crankshaft, remove the
needle bearing
⇒ "3.2 Replace the needle bearing in the crankshaft",
page 76 .
– If the clutch release bearing is worn, remove the clutch release
bearing ⇒ Gearbox; Rep. gr. 30 .
– Lightly grease the gearing of the gearbox drive shaft using lu‐
bricating grease for clutch disc spline ⇒ ETKA - Electronic
Catalogue of Original Parts .
– Check the centering of the clutch disc.
Vehicles with dual clutch gearbox
– If no needle bearing is installed in the crankshaft, install needle
bearing
⇒ "3.2 Replace the needle bearing in the crankshaft",
page 76 .
Continued for all vehicles
– Secure gearbox to engine.
– Install gearbox support bracket.
– Take up engine/gearbox unit with the engine mount -T10497- .
– Insert engine/gearbox unit into the body.
– Initially insert screws -arrows- for engine mount by hand as far
as the stop.
26
Rep. gr.10 - Removing and installing engine