Removing And Installing Lambda Probe G39 - Skoda Octavia III 2013 Workshop Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
7 - Support
8 - Exhaust gas pressure sensor 1 - G450-
❑ only for vehicles with engine identification characters CRKB, CRMB, CUNA
❑ removing and installing
⇒ "4.8 Removing and installing pressure sensor for exhaust gas 1 G450 ", page 349
9 - Screw
❑ 8 Nm
10 - Exhaust gas temperature transmitter 3 - G495-
❑ removing and installing
⇒ "3.2 Removing and installing exhaust gas temperature transmitter", page 403
❑ the thread of the exhaust gas temperature transmitter is coated and must not be coated additionally with
hot bolt paste
11 - lambda probe - G39- with heating for lambda probe - Z19-
❑ removing and installing
❑ 55 Nm
12 - Exhaust gas cleaner
5.2 Removing and installing Lambda probe
- G39-
Special tools and workshop equipment required
♦ Extension piece (No. 22) - T10491-
Removing
– Remove engine cover
⇒ "1.1 Removing and installing engine trim panel", page 10
– Take the electrical plug connection -4- for Lambda probe -
G39- out of its holder and disconnect, expose the electric
cable.
Volkswagen Technical Site: http://vwts.ru http://vwts.info
огромный архив документации по автомобилям Volkswagen, Skoda, Seat, Audi
352
Rep. gr.23 - Mixture preparation - injection
⇒ "5.2 Removing and installing Lambda probe G39 ", page 352
.