Connection Diagram For Vacuum Hoses - Skoda Octavia III 2013 Workshop Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
– Put the sliding ring -1- of the hand vacuum pump - VAS 6213-
into position -B- to ensure the pressure box is vented until the
pressure reaches the ambient pressure.
Check the voltage value
– Put the sliding ring -1- of the hand vacuum pump - VAS 6213-
in position-A- for "vacuum"
– Using the hand vacuum pump - VAS 6213- continue pumping
until the pressure gauge indicates a vacuum between
-650...-700 mbar.
– The ⇒ Vehicle diagnostic tester should now indicate a voltage
of 0.75 ± 0.02 V.
Voltage not OK.
Note
Version 1 is shown as an example.
– Release screws -1-.
– Adjust the voltage value
Voltage value o.k.
– Coat the screws with sealing varnish from the repair kit.
– Install the engine cover
⇒ "1.1 Removing and installing engine trim panel", page 10
– Start engine and erase fault memory ⇒ Vehicle diagnostic
tester.
1.4

Connection diagram for vacuum hoses

306
Rep. gr.21 - Turbocharging/supercharging
⇒ page 305 .
.