Removing And Installing The Exhaust Flap Control Unit J883; Removing And Installing Rear Silencer - Skoda Octavia III 2013 Workshop Manual

– Release screws -1-.
– Slacken screw -2- and remove air filter housing.
– Remove pre-exhaust pipe.
Install
Installation is performed in the reverse order, pay attention to the
following points:
Note
Replace gasket.
– Observe installation position of clamping sleeve between ex‐
haust gas cleaning module and pre-exhaust pipe
⇒ "1.1 Summary of components - front, middle and rear si‐
lencer", page 370 .
– Align exhaust system free of stress
⇒ "1.6 Aligning exhaust system free of stress", page 386
Tightening torques
♦ ⇒ "1.1 Summary of components - front, middle and rear si‐
lencer", page 370
1.3 Removing and installing the exhaust
flap control unit - J883-
For vehicles with engine identification characters CLHA, CLHB,
CRKB, CKFB, CKFC, CUPA, CRMB, CUNA
Removing
– Remove tunnel cover at bottom ⇒ Body Work; Rep. gr. 50 .
– Separate electrical plug connection -1-.
– Release screws -arrows-, remove exhaust flap control unit -
J883- .
Install
Installation is performed in the reverse order, pay attention to the
following points:
Tightening torques
Screws Tightening torque
-Arrows- 9 Nm
1.4

Removing and installing rear silencer

⇒ "1.4.1 Removing and installing rear silencer, vehicles with front-
wheel drive (engine identification characters CLHA, CLHB,
CRKB, CKFB, CKFC, CRVC, CRMB)", page 381
⇒ "1.4.2 Removing and installing rear silencer, vehicles with front-
wheel drive (engine identification characters CUPA, CUNA)",
page 383
⇒ "1.4.3 Removing and installing rear silencer, vehicles with four-
wheel drive (engine identification characters CLHA, CKFC,
CRMB, CUNA)", page 385
1.4.1

Removing and installing rear silencer,

vehicles with front-wheel drive (engine
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
Octavia III 2013 ➤ , Octavia III 2014 ➤
.
1. Removing and installing exhaust pipes/silencers
381