Skoda Octavia III 2013 Workshop Manual page 68

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
A - Crankshaft arrester - T10490- stud is positioned to the left of
the bore:
– Turn the crankshaft in the direction of rotation of the engine
until the stud -arrow- of the crankshaft arrester engages during
this rotary movement in the sealing flange.
– Tighten camshaft toothed belt pulley to 20 Nm.
B - Crankshaft arrester - T10490- stud is positioned to the right of
the bore:
– First turn the crankshaft slightly against the running direction
of the engine.
– Turn the crankshaft in the direction of rotation of the engine
until the stud of the crankshaft arrester engages during this
rotary movement in the sealing flange.
– Tighten camshaft toothed belt pulley to 20 Nm.
Continued if the timing is correctly set or has been corrected:
– Remove rig pins for diesel injection pump - 3359- and crank‐
shaft arrester - T10490- .
– Turn the crankshaft at the screw for timing belt gear 2 turns in
the direction of running of the engine until the crankshaft is
positioned shortly before "TDC".
– Repeat timing test ⇒ page 58
Caution
Risk of engine damage.
♦ The diesel injection pump rig pin - 3359- must not be used
as a counterholder for tightening the camshaft toothed belt
pulley.
– If it is now possible to lock the camshaft hub, tighten screws
-1- for toothed belt pulley Pos. -8-
⇒ "1.7 Assembly overview - toothed belt drive", page 44
end position using counterholder - T10172- with adapters -
T10172/11- .
– Tighten the nuts -2- for the toothed belt gear, high pressure
pump Pos. -4-
⇒ "3.1 Summary of components - high pressure pump", page
338 to the end position, to do so, use the counterholder -
T10051- .
– Repeat timing test ⇒ page 58
Assembling
Assembling is performed continuing in the reverse order, while
paying attention to the following:
Note
Replace gasket.
♦
Secure all hose connections with spring-type clips that comply
♦
with the series design ⇒ ETKA - Electronic Catalogue of Orig‐
inal Parts .
60
Rep. gr.13 - Crankshaft group
.
.
to the