Removing And Installing The Fuel Distributor - Skoda Octavia III 2013 Workshop Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
Caution
Risk of line break because of high pressure line being under
tension.
♦ Loosen fuel distributor and clamps for improved, tension-
free positioning of injection lines. If necessary, move the
fuel distributor slightly and turn the corresponding injection
unit slightly. The lines must be never bent or twisted.
– Suction off dirt from the sealing cone at the fuel distributor.
– Moisten thread of the nut with clean engine oil.
– Hand-tighten union nuts, ensure that the fit is tension-free.
– To tighten the high pressure lines on the fuel distributor and
injection units, use torque wrench -1- with tool insert SW 17 or
socket wrench insert - T40055- .
– Set balancing weight -1- on the high-pressure lines as shown
in the diagram.
– Check fuel system for tightness
⇒ "1.4 Check the fuel system for tightness", page 322
Tightening torques
♦ ⇒ "2.1 Summary of components - injection units (injectors)",
page 323
♦ ⇒ "2.2 Fuel distributor - summary of components", page 325
2.10 Removing and installing the fuel distrib‐
utor
Removing
Note
Safety precautions when working on the fuel supply system
♦
⇒ "2 Safety instructions", page 3
Observe rules for cleanliness
♦
⇒ "3.1 Rules of cleanliness", page 6
– Remove high pressure line between fuel distributor and the
high pressure pump
⇒ "2.9.1 Remove high pressure line between fuel distributor
and the high pressure pump.", page 334
336
Rep. gr.23 - Mixture preparation - injection
.
.
.
.